Rancho Mirage, CA

Spoke with Dennis regarding previous visit and findings Highly recommended replacing back bedroom system

Performed cooling maintenance on 2019 Lennox split system. Furnace is located in attic/access Grande bedroom closet. Changed out filter filters located at the wet home in ceiling. Cleared all electrical components of dust in debris, verified proper sequence of operation, checked, volts, amps, checked, capacitors, found starting amps, exceeding specifications, recommended, installed and tested compressor saver kit to prevent any further damage to compressor and internal windings and to assist compressor at startup and prolonged life of compressor. Verified refrigerant levels and line temperatures and took temperature split and cycled system. Cleared condensation line and washed condensing coil. Thermostat checked out OK, with recommended repairs system is now within manufacturers, specifications, and cooling and operating properly at this time of service.

Cooling maintenance on Bosch rooftop package unit. Changed out 24 x 24 filter located in lower wall, cleared all electrical components of dust and debris, verified proper sequence of operation, washed condensing coil and cleared condensation line. Thermostat checked out OK, system is within manufacturers specifications and cooling and operating properly at this time of service.

I maintained both systems

Cooling maintenance on two 2014 Rheem split systems furnaces are located in separate outside closets, filters are 16 x 25 and located with in filter racks, cleared condensation lines, changed filters, cleared all electrical components of dust and debris, verified proper sequence of operation, checked, volts, and amps, checked, capacitors, found starting amps for both systems, exceeding specifications, as well as system serial number 6851 low on refrigerant (living room unit)informed clients of my findings, recommended compressor saver kit, and installed compressor saver kit on system serial number 9520 (bedroom unit) and added 2 pounds of R-410A living room unit. And have a 21° split at supply and return. I had Client sign acknowledge form for refrigerant. Client is aware that charging system indicates a leak within the system. Washed condensing coils, thermostats, checked out OK. Systems are at life expectancy, and in poor condition due to age of units would recommend replacement to p

Performed cooling maintenance on two 2014 American standard split systems. Furnaces are located in attic. Left filters with Client, filters did not need to be changed at this time. Cleared all electrical components of dust and debris, verified proper sequence of operation, checked volts, and amps, checked start and run, capacitors, verified refrigerant levels and line temperatures and cycled systems. Cleared condensation lines and washed condensing coils. Thermostat checked out OK, verified that all zones are operating properly, washed filters for ductless unit in garage. Systems are within manufacture’s specifications and cooling and operating properly at this time of service

Answered questions

2018 model check cooling and electrical components everything is working properly at time of service

Performed annual AC maintenance on three 2006 York split systems FAU located inside garage. 16 x 25 x 2 filters did not need to be changed at this time. Checked amps, volts, capacitor, and cleaned electrical compartment. Checked refrigerant levels, superheat, subcool , and temperature split. Cleared lines and washed condensing coil. Client is aware that two of his system has weak blower motor capacitors. Systems are well beyond life expectancy, but are operating and cooling properly at this time. 74° ambient temperature.

2018 model,,casita mini split check cooling and electrical components everything is working properly at time of service

I Performed Maintenance on both the Cooling Systems. Also checked two 20x25x5 Filters and they’re clean. Both Cooling Systems are 2001 and 2005 models located on the ground. I found that the Living Room 4 ton Lennox System (S#57189) was two pounds low on R-410A. Client advised that another company added refrigerant to the system about 3 years ago. Advised client that when a system is low on refrigerant that there is a leak somewhere, I advised client that majority of leaks occur in the evaporator coil, and sometimes they occur in the condenser coil as well as the lineset. Advised client on doing a leak search via electronic leak detection, and lastly through isolation test. With the age of the system, advised client about replacing the system. Client chose to add refrigerant to the system. Advised of no guarantees on refrigerant. I added two pounds and tested the system. Both systems are past life expectancies, and advised on replacement. At the time of the service. Both systems are op

20/30 20/20 filter check cooling and electrical components everything is working properly at time of service

Upon arrival client stated noise coming from blower on system that had the condenser and coil installed. Found noise in blower wheel due to paper sucked in. Advised install of condenser and coil has nothing to do with blower wheel in furnace. Courtesy call

Installed new condensate pump. Tested for proper operation by pouring a gallon of water into pump. Pump drains water out. Tested and cycled cooling. Everything checked out in range. System is properly draining and cooling.

Provided customer an estimate to address miscellaneous electrical projects.

2017 model check cooling and electrical components found system low 2 pounds add refrigerant system cooling properly at time of service,,,,advice client system might have a refrigerator leak sent estimate with the first step of finding a refrigeration leak

check cooling and electrical components everything is working properly at time of service e

Wash condenser and filter check cooling and electrical components everything is working properly at time of service

Rooftop wash condenser replace 20/25 x2 filter check cooling and electrical components everything is working properly at time of service

Upon arrival client stated living area system not cooling and has a error code. Found error code e434 on Lennox communicating system stating communication issue. Found system has bypass its wireless communication hub. Other system has the hub. Checked indoor and outdoor unit. Reset system and systems error code went away. Cycled system and plugged in uv light. Advised client on missing communication hub. Advised I reset system and system is cooling however didn’t find why the issue occur in the first place. Advised will contact Lennox support for more information.

Estimate to install condenser fan motor. Ordered motor and motor coming in on Tuesday. Installed oem condenser fan motor on Heil unit. System properly running.

Performed a cooling maintenance on a new reinstalled American Standard split system unit. Check sequence of operation by checking out all electrical and refrigeration levels at this time. System is cooling down the house properly upon arrival. House was at 78° before leaving house was reaching temps of 74° also downsize 20 amp breaker to an 15 amp breaker. See pictures system is ready for final inspection as well as system is cooling down the house properly.

Upon arrival client stated bedroom system not working. Condenser installed two years ago. Found dual run capacitor dead. Replaced capacitor and tested. Checked both systems to make sure they are cooling.

Performed a cooling maintenance on a Lennox split system unit. System is about six years old, checked all electrical and refrigeration levels run capacitor rated for 70 was getting 64 informed clients that run capacitor is in danger of going out. Explain the reasons why recommending replacing today. Client will hold off on replacing. Will send estimate via email refrigeration levels at this time or within the range and system is cooling down the house to very low temperatures. Finish maintenance by washing down condenser unit and by changing out filters.

Performed cooling maintenances on (4) 2016 American standard split systems and ac pro split for garage. Changed customer supplied (2) Aprilaire filters , (2) 24x25, cleaned (2) washables and left with furnace closet for spare use as she already purchased (2) filters, and changed 20x25 garage furnace filter. Cleared condensation drains, cleaned condenser coils. Checked amps, volts, capacitors, refrigerant charges, and temperature splits. All systems are cooling to manufacture specifications. (5) Honeywell T6 thermostats working properly. Recommended surge protection to prevent damage to Air conditioners from surges or electrical spikes, etc. Also recommend adding hard start kits to all systems as they are pulling over max rated start amps (LRA). Adding hard start kits reduces the strain and wear on compressor motors during every startup. These allow smoother startups and can prolong the lives of the compressors (most expensive and important part of systems) .