Thousand Palms, CA

Coleman model 16/20 x2 Check heating and electrical components everything is working properly at time of service

Remove all existing ductwork under Mobil home. Install complete new R-8

Heating System Repair: A commercial facility reported insufficient heat in certain areas. Upon inspection, I discovered a malfunctioning circulator pump in their boiler system. I replaced the pump, ensuring hot water was evenly distributed for consistent warmth.

Smoke Detector Inspection: I meticulously inspected and tested all smoke detectors and CO2 alarms in a client's home. This thorough evaluation ensured all devices were fully operational and compliant with safety standards, offering protection for the residents during the winter months.

Heating System Repair: I was called to a home where the heating system failed to produce sufficient heat. Upon inspection, I found the issue was caused by a clogged air filter, which restricted airflow and compromised the system's performance. I replaced the filter and thoroughly cleaned the system to restore proper heating. After confirming the system's optimal function, I discussed our maintenance plans with the homeowner to ensure long-term reliability.

Performed annual heating maintenance on a 2020 American Standard Silver heat pump. FAU located on roof. Replaced 14x24 filter located in kitchen ceiling. Followed sequence of operations and checked voltage, amperage, capacitor, temperature rise, Freon levels, and cleared condensation line. Honeywell 8000 thermostat checked out operational. Everything checked out in range. System is working properly in heating at this time of service.

Attics check other heating and electrical components clean condensation line,,,,system are working properly at time of service see notes

Replace gas valve and thermocouple—-unit was cycled several times in heat—-system is running as designed—-confirmed no gas leaks from gas valve replacement—— monitored system for CO none detected—-system is operating per manufacturer specification

Replaced gas valve pilot now stays lit but system has further issues Will have management follow up with client

Systems gas valve does not stay lit. Ordered gas valve from US air valve will be in Monday or Friday.

Upon arrival client stated previous tech just out and heater not working. Found power switch was off on air handler. Turned on and cycled system.

Performed annual heater maintenance on Coleman downflow splits system with Trane condenser. We will be returning to change to 16 x 20 by one filters. Checked amps, volt, and cleaned burner compartment. Checked gas and static pressures. Also checked temperature rise. Read routed wires for surge protector. Found all electrical and safety components to be within manufacturer specifications. System is operating and heating properly at

Furnace Blower Motor Replacement: A homeowner noticed unusual noises coming from their furnace. My investigation revealed a failing blower motor that had worn bearings. I replaced the motor with a quieter, energy-efficient model, cleaned the blower assembly, and balanced the components. The furnace now operates noiselessly, maintaining optimal airflow and temperature control.

Heating Element Replacement: A homeowner complained of insufficient heat output from their furnace. My diagnostics identified a failed heating element that could no longer generate adequate warmth. I replaced the faulty element with a high-performance component, thoroughly tested the system, and calibrated it for optimal output. The homeowner now enjoys consistent and efficient heating.

AC Refrigerant Leak Repair: A homeowner reported that their AC system was struggling to cool the home. My inspection uncovered a refrigerant leak caused by a worn valve. I repaired the leak with precision, replaced the valve, and recharged the system with the proper refrigerant levels. Following the repair, I performed a full performance test, ensuring the system operates efficiently, restoring the home’s cooling capacity and improving energy efficiency.

Duct Sealing and Repairs: A homeowner experienced uneven temperatures and high energy bills, suggesting duct issues. I conducted a thermal imaging analysis and found leaks at several duct joints. Using advanced sealant and insulation materials, I addressed the gaps and reinforced weak points. This comprehensive repair improved air distribution, reduced energy waste, and enhanced overall comfort in the home.

Performed annual heating maintenance on 2007 American standard furnace located in outside closet. Changed 20 x 25 filter. Checked amps, volts, capacitor and clean burner compartment. Checked gas and static pressures also checked temperature rise and all safety switches. All electrical and safety components to be within manufactured specifications. System is operating and heating properly at time of service

Performed heating maintenance n 2016 Nordyne Downflow gas furnace in laundry room. Changed 20x30 filter inside fau. Honeywell 3000 thermostat working properly. Cleaned out burner compartment. Cleaned out electrical compartment. Zero carbon monoxide detected. Checked furnace gas fittings for leaks, none found. 10uf blower motor capacitor within range. Checked amps, volts, polarity, heat rise, gas pressures, safeties, and limits. Heating sequence of operations was performed properly. Informed about upcoming changes to our industry. Discussed refrigerant changes, increased pricing for refrigerant and equipment, and California’s gas furnace ban coming in 2030. Outdoor condenser is in rough condition, past life expectancy, and uses r22 refrigerant.

2013 Coleman Downflow gas furnace. Homeowner noticed thermostat (Honeywell 500) was blank. He replaced corroded batteries and display came on but no loads operational. Checked power to furnace and found panel switch in OFF position. Set power to ON. Tested system in heating from thermostat. System is heating properly now. Sequence of operations working to completion. Informed homeowner of diagnosis. Recommended Hyde’s maintenance plan to save %15 off todays call and any future repairs (for year plan) as well as 2x maintenance visits a year, and many member benefits. Homeowner declines at this time. Left brochure and informed about Hyde’s as a company.

Spoke with client client is going to clean evaporator coil himself

Check blower motor will and housing also check evaporator coil all components need to be cleaned

Performed annual heating maintenance on a 2013 Lennox split system. FAU located in attic/access in laundry room ceiling. Client had replaced media filter prior to arrival and changes it in the spring. Heating sequence of operations was performed properly. Checked gas pressures. Zero carbon monoxide detected. Checked temperature rise. Cleared condensation line. Checked water safety switch. Checked thermostat for any error codes and none were found. Everything checked out in range. Thermostat checked out operational. System is working properly in heating at this time of service.

Performed Daniel heater maintenance on Coleman furnace located in outside closet. Changed 14 x 14 by one need to return to change 16 x 16 16 by one filter. Checked amps, volt, capacitor, and cleaned burner compartment. Checked gas and static pressures also checked temperature rise and all safety switches. Cycled system from thermostat. Thermostat is operational. FAU is well past its life expectancy, but is heating at this time

Comfort heater service on Coleman downflow with 2010 American standard condenser. Fau located laundry room, condenser on south side of home. Replaced filter and cycled heating. Checked all components. System properly running within manufacturing specifications.

Comfort heater service on Coleman downflow split system. Fau located inside laundry room, condenser on east side of home. Replaced filter and checked all heater components. Blower capacitor within range. System properly heating to manufacture specifications.